Assembly Instructions...

SimpleFit Window Framers™ snap together in minutes. You’ll be hanging lights before you know it.

Package Contents:

For each glass pane within the ordered Kit Type:

  1. (4) Frame (2 top and 2 bottom custom cut pieces)
  2. (4) Corner Connectors
  3. (4) 3M™ Dual Lock™ Patches
  4. Hanger clips

Directions:

  1. Inspect the contents of your SimpleFit Window Framers™ shipping tube to be sure that all parts have been included.
  2. Lay out all parts separately for each glass pane on a flat surface.
    1. Note: Each banded frame set must stay together. That banded package represents the sized pieces for a specific pane of glass.
    2. Use your measurement worksheet to correlate which banded package goes to which glass pane of a window.
  3. Build out glass pane frame by laying out the four frame panels (a) in the shape of your glass pane.
  4. Insert corner connectors (b) to create a sturdy frame. Do not force, try another corner piece as the connection piece is directional, and not universal to all 4 sides.
  5. Insert hanger clips (d) into pre-cut grove in the frame. Clips will slide across the grove to allowing adjusting to accommodate placement of lights or ornaments.
    CAUTION: Do not add clips when frame is in the window, as pressure used to insert clips may break the window glass.
  6. Remove protective film from the RED side of the 3M™ Dual Lock™ patches (c) and carefully stick them into place on the four corners of the glass panes.
  7. Remove protective film from the opposite side of the 3M™ Dual Lock™ patches.
  8. Line up the four corners of the frame to the adhesive patches on the window pane. Position carefully, and press each corner of the frame to ensure it sticks to the window patches in place.

Your SimpleFit Window Framers™ are now complete and can now be easily removed and replaced any time you wish. Frames can be stored fully assembled or broken down and stored in the sturdy shipping tube.

Call 1-866-517-1394 or e-mail , if assistance is required or pieces are missing.

Your SimpleFit Window Framers™ are now complete and can now be easily removed and replaced any time you wish. Frames can be stored fully assembled or broken down and stored in the sturdy shipping tube.

3M™ Dual Lock™ Reclosable Fasteners are a fastening solution that can replace screws, bolts and rivets. The fasteners contain hundreds of mushroom-shaped stems that audibly "SNAP" together to form a secure attachment with strong adhesive backings that adhere to your substrate. Adjust, realign or reattach with ease, leaving your product with clean, smooth lines free of holes or interruptions.

Updated: 08 September 2010